Audio Technical Hand Held ATW-702

The Audio-Technical ATW-902A System 9 VHF Wireless Handheld Microphone System is designed for live sound reinforcement applications. The system consists of a wireless VHF receiver and a wireless VHF handheld microphone transmitter. The receiver utilizes two dipole antennas for extended range, and allows you to select your VHF transmission frequency from 169 to 172 MHz.

The receiver includes LED indicator lights for channel, RF, and AF peak. The back of the receiver includes a volume control knob, a squelch control knob, a balanced XLR audio output, and an unbalanced 1/4" audio output. The receiver also includes a power cord hook to prevent accidental pull-out of the DC power supply.

The handheld microphone transmitter is powered by two AA batteries and includes a battery status LED indicator, channel selection DIP switches, and a power/mute button.

Selectable VHF Transmission Frequencies

Select four channels from 169 to 172 MHz

Dipole Antenna for Extended Range

The receiver utilizes two antennas to improve the range of the system

Squelch Control

The receiver features a squelch adjustment knob that controls the threshold for the radio signal that regulates audio output. If the radio signal from the microphone drops below the threshold, the squelch control mutes the audio output to prevent the transmission of radio interference and white noise from entering the speakers

• Type: VHF High Band
• Operating Frequencies: 169 to 172 MHz
• Modulation Mode: FM
• Maximum Deviation: ±10 kHz
• Dynamic Range: ≥90 dB (A-weighted), typical
• Total Harmonic Distortion (THD): <1% (at 1 kHz, ±10 kHz deviation)
• Operating Range: 200' (61.0 m), open range environment with no interfering signals
• Operating Temperature Range: 40 to 110°F (4 to 43°C), battery performance may be reduced at very low temperatures
• Frequency Response: 80 Hz to 13 kHz
• Receiving System: Non-diversity, single-channel, dual-antenna system
• Image Rejection: 50 dB minimum
• Audio Output: Nominal Output Level
• Balanced XLR: 350 mV (1 kHz modulation, 10 kHz deviation, 100-kOhm load)
• Unbalanced 1/4" (6.3 mm): 700 mV (1 kHz modulation, 10 kHz deviation, 100-kOhm load)
• Power Supply: 100 to 240 VAC (50/60 Hz) to 12 VDC at 0.5A (center positive) switched mode external power supply
• Dimensions: 7.5 x 1.8 x 5.1" / 190 x 46.2 x 129 mm
• Weight: 12.0 oz / 337 g
• RF Power Output: 10 mW
• Spurious Emission: Following federal and national regulations
• Batteries: 2 x 1.5 V AA (not included)
• Battery Life: 8 hours (alkaline), depending on battery type and use pattern
• Dimensions: 9.9 x 2.1" / 251.8 x 53.5 mm
• Weight: 9.2 oz / 260 g (without batteries)